EH Polyurea Basecoat (Slow Cure) 15 Gallon Kit

Login to view price.

EHEH Polyurea Base Coat SC

100% Solids Polyurea Primer/Basecoat is designed for broadcast systems. Excellent adhesion, extended pot life, and rapid cure, this basecoat offers:

  • Walkability in 1-2 hours, 4-6 hours full return to service
  • Extended pot life for maximum broadcast window
  • Easy mix 2:1 ratio
  • Extreme flexibility and elongation properties
  • Zero VOCs
  • Pre-tinted to ensure ease and consistency
  • Low temp cure
  • Holds back 4 lbs of Moisture Vapor Emissions

Product Properties

  • Tabor Abrasion Mg Loss ASTM D4060 30
  • Tensile Strength ASTM D412 6000
  • Falling Sand A Resistance ASTM D968 30
  • Elongation ASTM D412 129%
  • Compressive Strength ASTM D965 9,400 PSI
  • Tear Strength (PLI) ASTM D1737 350
  • Flexibility (½ Mandrel) ASTM D2794 PASS
  • Gloss ASTM D523 90+

Product Cure Times

  • Tack Free Time at 70 degrees F 40-75 mins
  • Hard Dry 1-2 hours
  • Foot traffic 1-2 hours
  • Recoat window 8 Hours
  • Pot Life 45 min
  • Working Time 30-35 min

Product Adhesion

  • Concrete Substrate Failure 575 PSI
  • Steel delamination 1200 PSI
  • Wood substrate failure 600 PSI

Substrate Preparation

New concrete requires a 28-day cure with CSP2-3 before coating. Existing concrete is prepared by removing all paint, adhesives, oil, dust, debris, etc. The surface should be clear and pass MVT. Use EH Spall or EH Fast crack filler before beginning the application process. 


Three cure speeds available for any ambient temperature. Summer, Winter, Tropical. Each speed comes with the pre-tint option of tan or gray but custom colors are available. All configurations available in 15-gallon kits.

Recommended Coverage

Based on 1600 sq ft per gallon at 1 mil thickness, will vary based on substrate condition and application process. Ground floors require less product than shot-blasted floors.


Store up to 12 months tightly sealed, away from direct sunlight at 40 degrees - 95 degrees Fahrenheit. 

Mixing Ratio

Standard mix ratio of 2A:1B. Always premix A side using a low speed for 2 minutes. Never whip the product; introducing air into the product will reduce pot life. Never mix more than 3 quarts at a time which will cover approximately 200-250 sq ft. Mix even smaller batches for edges, verticals or in high heat conditions. This product may be reduced with up to 10% total mixed volume with Acetone. 


Clean tools with acetone immediately after use. 


The technical data and any other printed information furnished by Epoxy Hub is true and accurate to the best of our knowledge. This product conforms to in-house quality control procedures and should be considered free of defects. Due to wide range of application, storage conditions, coverage, workmanship, over spray, or injuries resulting from the use of this product liability, if any, for this product will be in the form of replacement materials provided the product was stored correctly and applied during the shelf life. The possibility exists to warrant this product on a specific application basis under specific written application instructions from Epoxy Hub.